Mapei Ultraplan Renovation Screed is a Fibre Reinforced Self-Levelling compound, designed for use in the refurbishment of existing floors in both commercial and domestic applications. It can be hand or pump applied. It is used for interior levelling, smoothing & removing differences in thickness from 3-30 mm on new or existing concrete, screed, stone, terrazzo & ceramic tiles, old & new timber, floor boards, chip-board panels, plywood, parquet. Suitable where good resistance to loads is required, also for wheelchair traffic & underfloor heating systems. Sold in 25Kg Bags.
Ultraplan Renovation Screed is a fibre reinforced self levelling compound, designed for use in the refurbishment of existing floors in both commercial and domestic applications, it can be hand or pump applied.
WHERE TO USE
Used for interior levelling, smoothing and removing differences in thickness from 3 to 40 mm on new or existing concrete, screeds, stone, terrazzo and ceramic tiles, old and new timber floors, floor boards, chipboard panels, plywood, parquet. Ultraplan Renovation Screed is suitable where good resistance to loads is required, also for wheelchair traffic and underfloor and undertile heating systems.
Preparation of the Substrate
The substrate should be solid, free of dust, loose particles, paint, oil, gypsum residues or other contamination that could compromise the bond. Timber substrates should be clean and solidly fixed, open joints should be sealed with Nivorapid mixed with Latex Plus. Cementitious surfaces that are not sufficiently solid must be removed or, where possible, consolidated with Prosfas or Primer EP. Cracks in the substrate should be repaired with Eporip. The substrate should be primed with Mapeprim SP or Eco Prim Grip prior to the application of Ultraplan Renovation Screed.
Preparing the mix
Pour a 25 kg bag of Ultraplan Renovation Screed into a bucket containing 4.25-4.5 litres of clean water and mix with a low speed electric mixer to obtain an homogeneous, self-levelling, lump free mix. Larger quantities of Ultraplan Renovation Screed can be prepared in suitable mixers. After 2-3 minutes of slackening, the mix should then be restirred and then it is ready for use. The amount of Ultraplan Renovation Screed mixed at any time must be used within 30-40 minutes (at a temperature of +23°C).
Apply in a single coat from 3 to 40 mm in thickness. Depending on the thickness required, a aeration roller may be used. The self levelling properties of Ultraplan Renovation Screed will provide a surface ready to accept all kinds of floorcoverings.
Approx 6 m² at 3 mm thickness.
25 kg bags.
12 months in a dry place and in the original un opened packaging. The product complies with the conditions of Annex XVII to Regulation (EC) N° 1907/2006 (REACH), item 47.
SAFETY INSTRUCTIONS FOR PREPARATION AND APPLICATION
Ultraplan Renovation Screed is an irritant containing cement that when in contact with sweat or other body fluids causes irritant alkaline reactions and allergic reactions to those predisposed. It is recommended to use protective gloves and goggles and to take the usual precautions for handling chemicals. If the product comes in contact with the eyes or skin, wash immediately with plenty of water and seek medical attention. For further and complete information about the safe use of our product please refer to our latest version of the Material Safety Data Sheet.
PRODUCT FOR PROFESSIONAL USE.
Whilst we try to ensure that any advice, recommendations or information given in our literature is accurate and correct, we have no control over the circumstances in which our product is used. It is therefore important that the end users satisfy themselves that the product and conditions are suitable for the envisaged application. No warranty can be given or responsibility accepted other than, that the product supplied by us will meet our written specification. End users should ensure that our latest product data and safety information sheets have been consulted prior to use.