Ireland & Northern Ireland

062 76265
085 1234899

Mon - Fri: 9:00 - 17:30


We can supply a wide range of tactile paving studs and hazard warning strips.

Please check the products below and contact us for advice. 


A range of tactile paving studs which are fully compliant to the building regulations and the Disability Discrimination Act (DDA)

The studs have been tested by Ceram and all tactile paving stainless steel studs have passed the slip test in both wet and dry conditions.

Tactile Paving is a system of textured ground surface indicators found on many footpaths, stairs and train stations platforms to assist blind and vision impaired pedestrians.

Tactile warnings provide a distinctive surface pattern of “truncated domes” or cones which are detectable by long cane or underfoot which are used to alert people with vision impairments.


A range of corduroy strips which are fully compliant to the building regulations and the Disability Discrimination Act (DDA).

The corduroy strips have been tested by Ceram and all have passed the slip test in wet and dry conditions.

This form of tactile paving has raised ribs to warn blind and partially sighted people of a potential hazard ahead. The ribs, spaced at 50 mm centres, are installed at right angles to the direction of travel.


The purpose of the guidance path surface is to guide visually impaired people along a route when the traditional cues, such as a property line or kerb edge, are not available. It can also be used to guide people around obstacles, for example street furniture in a pedestrianised area.


A range of demarcation studs which are suitable for any situation. The low domed range has been designed as a marker stud which is not a trip hazard as there is no leading edge and the height is low and will not confuse the blind or partially sighted.

The studs range from the small 25mm diameter studs which are used for demarcating boundary lines and eating areas outside coffee houses and the larger studs which can be used on roads or pathways to demarcate parking bays or boundary issues.

The low domed demarcation studs are available in sized from 25 mm – 90 mm diameters


Visual aids for steps are a retro fitted product that shows a colour contrast and helps people to see the edge of steps. These can be fitted to existing steps such as hotels and office blocks without causing too much disruption as there is no need to replace the steps.

We can manufacture numbered studs for car parking bays or for houses.

We have manufactured studs for disabled bays and cycle ways.


Offering a Unique Range of Innovative Safety Products. Approved Application / Single Point Guarantee – Actively Endorsed by Network Rail and Fully Compliant with all DfT requirements.


We have  a range of deterrents which stops skateboarders, roller bladders and BMX bikers from damaging the edges of expensive hard landscape installations and material such as wall tops, copings, steps, benches ect.

We can manufacture 35 mm diameter spheres to fit onto the edge of walls and copings. These can be machined to any profile from square 90 degree corners to any radius required. The 35 mm spheres can been manufactured to bolt onto tubular handrails.